With select lens for detection with animal access.
For automatic switching of ABB-free@home® actuators dependent on movement and brightness.
Switch-off delay of the actuator can be programmed via the web interface of the System Access Point.
For switching 127 V~/230 V~ consumers.
With integrated switch actuator.
Switching function is available also without prior programming (pre-configured).
Configuration can be changed later via the web interface (groups, scenes, etc.).
The bus can be connected via enclosed terminal block.
When installing in the flush-mounted box, a spatial division between the bus cable and 127 V/230 V installation cable is to be adhered to! If this minimum distance is not possible, use electronic boxes or insulating tubes.
Bus voltage: 24 V
Outputs: 1 Normally open contact, potential free
suitable for: ohmic
Rated output: 2300 W
Rated current: 10 A
suitable for: capacitive
Rated output: 2300 VA
Rated current: 10 AX
Protection class (device): IP 20
Temperature range (device): -5 °C - 45 °C
Storage temperature range: -20 °C - 70 °C
Detection range: frontal: 6 m, lateral: 3 m
Detection range 2:
Brightness limit value: 1 Lux
Detection angle: 180 °
Dimensions: (L x W x D): 71 mm x 71 mm x 53 mm
Mounting depth: 32 mm
Position for installation: vertical
Mounting height: 1.1 m - 1.3 m
Programming only with bus voltage applied via the web interface of the System Access Point.
Additional information about commissioning and operation is contained in the system manual and the online operating manual of the current Online-Catalogue.