Busch Watchdog 180 comfort sensor II

Comfort indoors!

A flush-mounted PIR motion detector must have a good appearance but it is equally important that it fulfils its purpose well. If a detector is too flat, it will sacrifice part of its performance range due to pure physical reasons. The Busch Watchdog 180 comfort sensor II is exemplary, both in form and function. Despite its compact design a distance of 12 m at the front and 8 m on both sides is covered perfectly. In this way, motion detectors of this generation have an astonishingly wide detection area, especially when approached from the front.

As the Busch Watchdog 180 comfort sensor II would say, your wish is my command! Switching-off delay time and brightness values can be determined individually. An easily accessible sliding switch on the front of the Busch Watchdog 180 comfort sensor II enables the "Permanent lighting", "Automatic" and "Off" modes. Besides the version for incandescent lamps, you can switch any other illuminant versions such as low-voltage halogen or energy-saving lamps.

In combination with the Busch Universal Dimmer®, the Busch Watchdog 180 comfort sensor II does not switch the light off suddenly but dims the lighting down slowly within 60 seconds. In this way there is no danger of suddenly standing in the dark. Ideal for stairways and large corridors.

Depending on the room conditions, it could be beneficial to connect an additional push switch (push-to-close). For example, for being able to enter a room that does not lie within the monitoring range of the motion detector. In this particular case, all the flush applications can be "remotely controlled" by a separate push switch - also at a later stage.